I built an Ugly Face last week and took some pictures. This uses the Ugly face PCB I made and the typical DIY stompbox parts. I used the alpha 12mm pots in a B sized box. The more common 16mm pots would also work.
Building an Ugly Face
Tags:
Comments
4 responses to “Building an Ugly Face”
-
Why do you use different caps on some pics?
-
Good eyes, when i took these pictures I had actually built two Ugly faces. I realized I had a missed a few pictures with the first build and took some more pictures with the second build. The caps were just what i had on hand and the choices don’t really have any effect. Even the values are not that critical. I have a drawing of a layout and the part values I use under the ugly Face link on my site.
-
-
I’m about to build an ugly face and was a bit worrying about the caps, but good to hear that its not that much critical.
And thanks a lot that you put out your layout.
Keep up your amazing work! -
howdy,
is it possible to purchase a pre-built UF from you?
best,
m
Leave a Reply to junge Cancel reply