Haunting Mids project

What’s Haunting Mids?

Haunting Mids is a Big Muff variant. In a nutshell it’s the input buffer, and first two clipping stages from the regular Big Muff circuit. It drops the tone control and the output buffer of the original circuit. There are a few other changes in part values but the the circuit is otherwise the same.

Haunting Mids Fuzz is not to be confused with JHS pedals Haunting Mids which is a completely different circuit that came later.

I created this PCB layout from version 3 of the original Haunting Mids. I made small change by moving the sustain/gain control to the outside of the box. The original circuit used an internal trim pot with only the volume accessible from the outside.

this video compares 5 Big Muff Variants, Haunting Mids in is in the Middle


Another demo of the Haunting Mids



PCBs

The PCB was designed in Eagle PCB. You can order boards from OSH Park for fairly cheap but you must order three. You can order boards here:

https://oshpark.com/shared_projects/Wu8UpzQE

Build

this should be a pretty easy build. Without the tone control and output buffer there are fewer parts than the original Big Muff. Pots and LED are mounted to the board. And most of the off board connections are lined up along the bottom of the board for easy wiring.

The parts are standard and easy to find. You should be able to order all of the parts at Tayda.

Capacitors
C1220n
C2470p
C3150n
C4150n
C5470p
C6470n
C7150n
C8470p
C9470n
C10220n
C1147µ
Pots
VOLUME A100k
SUSTAINA100k
Diodes
D11n4001
D2 LED Red 3MM
D3 LED Red 3MM
D41n4742
D51n4742
D6 LED
Transistors
Q1BC337
Q2BC337
Q3BC337
Resistors
R133k
R282k
R3120r
R4470k
R518k
R61k
R78k2
R856k
R9100r
R10470k
R1110k
R128k2
R1382k
R14120r
R15470k
R1618k
R17RLED


Haunting Mids Fuzz schematic


The circuit shows BC337 transistors but these don’t seem to be so special. You should be able to replace these with just about any NPN device. The usual suspects 2N3904 and 2N5088, or maybe 2N5089 if you want more gain.

The diodes are the same. You can probably experiment with anything for diodes in this circuit. The choices here are interesting definitely try them. But if don’t have these parts or can’t get them use what you have!

Wiring


Posted

in

by

Comments

One response to “Haunting Mids project”

  1. […] Moderate – Transistor circuits: Tone Bender, Big Muff, Haunting Mids […]

Leave a Reply to Pedal Workshop at Noisebridge – Super-Freq Cancel reply

Your email address will not be published. Required fields are marked *